Vortice Vort HRW 60 Mono Evo HCS Mode D'emploi page 36

ENGLISH
Parameters programming
By means of appropriate actions on the keyboard buttons, it is possible to reset the clogged filter counter, or
program the unit's operating parameters, as specified below:
To entry in programming mode:
• Press simoultaneously all the three buttons (SPEED - MODE - FUNCTION).
• LED 5 turns on white.
• Press the buttons in the following sequence: SPEED - SPEED - MODE - FUNCTION - FUNCTION – MODE.
To set the relative humidity threshold:
• Press the SPEED button.
• The currently set threshold is displayed by lighting one of the white LEDs 1, 2 or 3 depending on whether the
value is 60%, 75% or 90% (the default value is 75%).
• Press SPEED button to modify the threshold value.
• Press the FUNCTION button to confirm.
• All the speed LEDs from 1 to 5 will blink briefly to indicate that the value has been stored and the device will
return to normal operation.
• If you do not press the FUNCTION button within 20 sec, the device will return to normal operation without
storing.
To select cycle time:
• Press MODE button.
• The currently set time is displayed by lighting one of the white LEDs in position 1, 2 or 3 depending on whether
the time is 50, 60 or 90s. (Default value = 60s).
• Press the SPEED button to change the value.
• Press the FUNCTION button to confirm.
• All the speed LEDs from 1 to 5 will flash briefly to indicate successful storage and the device will return to
normal operation.
• If the FUNCTION button is not pressed within 20 sec, the device will return to normal operation without
memorizing.
NOTE: Cycle time programming can only be carried out on the unit set as master.
To select the clogged filter alarm interval:
• Press the FUNCTION button.
• The time currently set is displayed by lighting one of the white LEDs in position 1, 2 or 3 depending on whether
the interval is equal to 90, 180 or 365 days.
• Press the SPEED button to modify the value.
• Press the FUNCTION button to confirm.
• All the speed LEDs from 1 to 5 will blink briefly to indicate that the storage has taken place and the equipment
will return to normal operation.
• If the FUNCTION key is not pressed within 20 sec, the device will return to normal operation without
memorizing.
To reset the clogged filter counter:
• Press the SPEED - MODE - FUNCTION buttons simultaneously.
• Press the buttons in the following sequence: Mode - Mode - Speed - Speed - Mode - Mode.
• Press the Function key within 20 sec.
• All the speed LEDs from 1 to 5 will blink briefly to indicate that the reset has taken place and the device will
return to normal operation.
• If the FUNCTION button is not pressed within 20 sec, the device will return to normal operation without having
reset the filter timer.
Note: for regular operation between multiple devices, it is necessary to set the type of unit
!
(Master / Slave and Even / Odd)
36