Vortice Vort HRW 60 Mono Evo HCS Mode D'emploi page 25

ENGLISH
Description and use
Vort HRW 60 Mono Evo HCS / Vort HRW 60 Mono Evo HCS WiFi (hereinafter "the device") is a decentralized
heat recovery ventilation system, which can be installed on perimeter walls with thickness between 283 and 700
mm, inside holes with a nominal diameter of 160 mm.
The device has a maximum air flow rate of 60 m
temperature and ambient sensors. The sensors allow the automatic operation of the device ("Auto HR%", "Auto
Comfort", "Auto night" functions, Use paragraph).
Maximum absorbed power: 8W
General features:
- 5 speeds corresponding to 5 airflows.
- 1 input suitable for remote connection with cable compatible with external modules "VORTICE C TEMP"
(temperature sensor) and "VORTICE C HCS" (humidity sensor) or equivalent. Cable length≤30m.
- 1 direct output for fan control.
- RS485 communication BUS to synchronize together pairs of devices.
- Integrated WiFi module for synchronizing different units (Mesh network, WiFi models only)
- Long-term timer (3/6/12 months) with daily increase for filter clogging control.
- Insulation class: II.
- Power supply: 220-240V ~ 50-60Hz.
Compliance
• This appliance can be used by children no less than 8 years of age
and by individuals with limited physical, sensory or mental capacities,
or by inexperienced or untrained individuals, provided that they are
supervised or have been instructed in safe use of the appliance and
understand the associated risks. Children must not play with the
appliance. Cleaning and maintenance procedures that can be
undertaken by the user must not be entrusted to children, unless
under supervision.
• These appliances are designed for use in residential and commercial
properties.
• The appliance must be installed by a professionally qualified
electrician.
• The electrical system to which the product is connected must be in
compliance with applicable regulations.
• An omnipolar switch with a contact opening distance of 3 mm or
higher should be provided for installation, enabling complete
disconnection under overvoltage category III conditions.
• Products equipped with single-phase wiring (M) engines ALWAYS
require connection to 220-240V (or only 230V where required)
single-phase lines. Any kind of modification shall be considered as
product tampering and shall nullify the relative warranty.
• Precautions must be taken to prevent gas coming from the gas flue
pipe or from other fuel combustion units from entering into the room.
• Fans have been designed to be mounted on external walls.
3 /h (in boost mode), and has a remote control and relative humidity,
25