Chicco I-Move Mode D'emploi page 22

WARNING: Incorrect removal of the hood can break the
fastener parts.
VISOR
3 – The hood is fitted with an exclusive sun visor. When
not in use, the visor can be folded away inside the hood
(Diag. 3).
REAR HOOD OPENING
4 - The hood also has an adjustable rear opening to en-
sure sufficient air circulation; to open it, unzip the flap and
fold it away neatly into the pocket behind the hood (Diag.
4B).
INTERNAL LINING AND COVER
5 – To fit the internal lining inside the carrycot: position the
fabric part over the plastic frame and use the velcro straps
on the outside of the carrycot to fasten it in place (diagram
5A). Position the mattress on the carrycot's adjustable
backrest using the pocket on the back (Diag. 5B). Fasten
the cover to the carrycot using the zip (diagram 5C), once
it has been assembled, it can be opened from either side.
COMFORT SYSTEM – ADJUSTABLE BACKREST
6 - The backrest of the carrycot can be adjusted to various
positions.
To raise and lower the backrest, turn the knob on the out-
side of the carrycot where the baby's feet will lie (diagram
6).
WARNING: It is recommended to air the carrycot when it
has been used for a long time.
AIR VENTS
7 - The carrycot is fitted with two exclusive air vents. To
improve the circulation of air inside the carrycot, pull the
tabs backwards as seen in Diagram 7.
CARRYCOT HANDLES
8 – The carrycot has a practical carrying handle that can be
adjusted to three different positions (diagram 8).
A) Transportation
B) Intermediate
C) Rest
9 – To bring the handle into a vertical position (from the
rest position), grasp the centre and pull it upwards until
you hear it click into position (Diag. 9A); to return the
handle to the rest position, press the two buttons on the
handle base at the same time and then turn it downwards
(Diag. 9B).
WARNING: The carrycot must never be carried with the
handle in the intermediate or rest position; it can only be
carried with the handle in the transportation position.
WASHING
The hood, the internal lining of the carrycot and the mat-
tress are all removable and washable; please follow the
washing instructions indicated on the labels carefully.
10 – Remove the hood from the carrycot following the in-
structions in Point 2 (Diag. 10).
11 - Remove the padding from the mattress from the open-
ing on the back of the slipcover (Diagram 11).
12 – To remove the carrycot internal lining, open the velcro
fasteners on the outside of the carrycot and pull the fabric
out (Diag. 12)
USING THE CARRYCOT AS A PRAM
This carrycot can only be used as a pram when assembled
on the I-MOVE stroller.
FASTENING THE CARRYCOT TO THE STROLLER FRAME
Remove the stroller seat following the relative stroller in-
structions.
13 – Grasp the handle in the transportation position and
place the carrycot on the stroller frame hook-on system
(Diag. 13A). To make this phase easier, there are two ar-
rows, one on the stroller frame and one on the carrycot:
the device will click into place when the two arrows are
perfectly aligned (Diag. 13B).
WARNING: pull the carrycot upwards to check it is firmly
fastened in place before using it.
REMOVING THE CARRYCOT FROM THE STROLLER
FRAME
14 – Move the handle to a vertical position (transportation
position) until you hear it click into position (Diag. 14).
15 – Pull and hold the grey handle on the back of the pram
(Diag. 15A), then lift the carrycot off the stroller structure
(Diag. 15B).
WARNING: the carrycot can be fastened and unfastened
with the baby inside; these procedures could prove more
difficult due to the weight of the baby. Be very careful
when performing the above indicated procedures.
WARNING: it is highly recommended to assemble the car-
rycot on the stroller frame in parent-facing mode, with the
stroller handle facing the fixed rear wheels.
ACCESSORIES
16 – A practical mosquito net can also be fitted on the car-
rycot. The mosquito net is stored inside the pocket near
the baby's feet (Diag. 16A). Use the internal zip to fasten
the mosquito net in place, as seen in Diag. 16B. Then use
the elastics to fasten the mosquito net to the hood.
Please find below the washing symbols and relative mean-
ings:
Hand wash in cold water
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
CAR KIT
COMPONENTS
Car belt fastener buckles (2 pieces)
VERY IMPORTANT:
PLEASE READ CAREFULLY
• carefully read this instruction manual before using the
product.
- Read these instructions carefully before fitting and in-
22