Jacuzzi J-500 Série Manuel D'installation Et Utilisation Et Entretien page 53

I
This must be repaired only by a qualified authorized service
organization or service technician.
Monitors the controller temperature.
"OPEN AMBIENT TEMP SENSOR" The temperature sensor
is not functional. Heater is disabled.
I
This must be repaired only by a qualified authorized service
organization or service technician.
Monitors the controller temperature.
"CLOSED FLOW SWITCH ON START-UP" Flow switch is
non-functional. Closed or shorted flow switch on system start-
up (system disabled).
I
Contact your authorized dealer or service organization.
"FROZEN ON START-UP" Flow switch is non-functional.
Shorted flow switch on system start-up (system disabled) and
freeze condition detected.
I
Contact your authorized dealer or service organization.
"COOL WARNING" Spa water is more than 20°F/-6.67°C
cooler than the temperature set point, the circulation pump and
heater will automatically activate to provide freeze protection.
The spa will stay in this mode until the water temperature
reaches 15°F/-9.44°C below the set temperature.
I
No corrective action is necessary.
Note: The heater icon (
(
con ) will be displayed under the temperature.
ON
96
"FREEZE PROTECTION" A potential freeze condition has
been detected. No action is required. Jets pump(s) operate
until the spa is out of danger. No corrective action is necessary.
I
If condition persists, contact your authorized dealer or serv-
ice organization.
"OVERHEAT PROTECTION"
Do not enter the water!
Water temperature is above acceptable limits. Heater is deac-
tivated. Remove spa cover to speed cooling.
I
If condition persists, contact your authorized dealer or serv-
ice organization.
Note: The heater icon (
con ( ) will be displayed under the temperature.
Risk of Hyperthermia (over-heating) Causing Severe
Injury, burns, or welts.
"WATCHDOG PROTECTION"
DO NOT ENTER SPA!
Water temperature is above acceptable limits. Your spa is deac-
tivated. Remove spa cover to speed cooling.
ON
) will be blinking and the error i-
6:45 PM
ON
) will be blinking and the error i-
I
If condition persists, contact your authorized dealer or serv-
ice organization.
Note: The heater icon (
(
con ) will be displayed under the temperature.
"WATCHDOG FREEZE PROTECTION"
Spa water is below 40°F/4.4°C. Jet pumps operate until the spa
is out of danger.
I
Contact your authorized dealer or service organization.
Note: The heater icon (
con ( ) will be displayed under the temperature.
"CONTROLLER OVERHEAT PROTECTION"
Controller temperature has exceeded acceptable limits. If con-
dition persists, provide shade for equipment side of spa.
I
Contact your authorized dealer or service organization.
Note: The heater icon (
(
con ) will be displayed under the temperature.
"PANEL COM ERROR"
The topside controller is having trouble communicating to your
spa.
I
Contact your authorized dealer or service organization.
"STEREO COM ERROR"
The stereo is having trouble communicating to your spa.
I
Contact your authorized dealer or service organization.
"CLEARRAY REPLACEMENT REMINDER"
Reminder
It's time to replace your CLEARRAY bulb.
Contact your authorized dealer for replace-
ment parts.
reset snooze
This message will appear when the CLEARRAY bulb reminder
time has expired.
I
The CLEARRAY bulb must be replaced.
"PROCLARITY/PROCLEAR FILTER REMINDER"
Reminder
It's time to clean or replace your ProClarity
and ProClear filters. Contact your autho-
rized dealer if new filters are needed.
reset snooze
This message will appear when the filter reminder time has
expired.
I
Remove the ProClarity/Proclear filters and filter/debris bag
for cleaning or replacement.
"PROCLARITY DEPTH FILTER REMINDER"
53
ON
) will be blinking and the error i-
ON
) will be blinking and the error i-
ON
) will be blinking and the error i-