Jacuzzi J-500 Série Manuel D'installation Et Utilisation Et Entretien page 35

WARNING!
Do not get in the spa until the quantity of disinfectant
has not dropped below the level recommended by the
manufacturer and/or by your retailer.
I
Set Spa To Heat
To warm spa water to a comfortable temperature, follow these
steps:
The display on the control panel displays the actual temperature
( (
of the spa water. Tap ) or ) to increase or decrease
the water temperature in 1 degree increments.
The heater will turn off 1 degree above set temperature and turn
on 2 degrees below set temperature.
Important Heater Details:
The maximum temperature for which the spa can be set is 40°C
(104°F) and the minimum is 18,33°C (65°F).
Setting the thermostat at maximum will not accelerate the heat-
ing process. This will only result in a higher ultimate tempera-
ture.
The heater operates until the water reaches 1 degree above
the programmed "set temperature, " then turns off. The heater will
reactivate after the water cools to approximately 1 degree be-
low the "set temperature. "
Place Cover On Spa
Keeping the insulating cover in place anytime the spa is not in
use will reduce the time required for heating, thereby minimiz-
ing operating costs.
The time required for initial heat-up will vary depending on the
starting water temperature.
Leave spa cover open during this step to allow excessive chem-
ical vapors to exit spa, protecting pillows and plastic knobs from
chemical attack. If spa is indoors, open doors and windows for
proper ventilation. Turn on all spa jet pumps for 1 hour, open all
air controls, and place all massage selector knob(s) in their cen-
ter "combo" position.
Note: You will need to activate the jet pumps every 20 minutes
since these functions have an automatic 20-minute time-out
that turns them off.
35