Model Assembly - Horizon Hobby E-Flite EFL FW 190A 1.5m BNF Basic Manuel D'utilisation

Model Assembly

Horizontal Stabilizer Installation
1. Slide the horizontal tail tube (A) into the hole in the rear of the fuselage.
2. Install the 2 piece (left and right) horizontal tail as shown. Ensure the
control horn faces down.
3. Secure the 2 piece horizontal tail in place with 2 screws (M3 x 10mm) (B)
included.
4. Attach the ball link (C) to the elevator control horn's outermost hole using
the included (M2 x 8mm) screw. Use a 2mm hex wrench to tighten the nut
and screw.
5. Ensure the elevator and rudder servo arms are in the correct position, then
adjust the linkage to center them.
Disassemble in reverse order.
Screw Chart
Location
Elevator ball link screw
Wing screw
Horizontal stabilizer screws
Spinner screw
Propeller screws
Tail wheel mount screws
Hands free servo plugs screws
Servo cover screws
Landing gear door cover screws
(inside)
Landing gear door cover screws
(outside)
Retract cover mount screws
Wheel axle hub screws
Retract motor mount screws
Wing plug screws
X Mount screws
Motor mount screws
Ball link clevis screws
Size Screw Quantity
M2 x 8mm 1
M3 x 32mm 4
M3 x 10mm 2
M3 x 32mm 1
M3 x 16mm 6
2.0 x 8 4
2.0 x 8 8
2.0 x 8 8
2.0 x 12 16
2.0 x 6 2
2.0 x 8 4
4.0 x 25 2
3.0 x 16 8
2.0 x 8 16
3..0 x 16 4
4.0 x 10 4
2.0 x 8 6
A
B
B
M3 x 10mm
Countersunk Machine Screw
EN
C
C
M2 X 8mm
E
A
R
5