Propeller Installation - Horizon Hobby E-Flite EFL FW 190A 1.5m BNF Basic Manuel D'utilisation

Model Assembly Continued
Cannons, Guns, and Pitot Tube Installation
1. Install the cannons, guns and pitot tube on the wing by screwing them into
their locations as shown.
Disassemble in reverse order.
Optional Drop Tank Installation
1. Remove the drop tank mount cover (A) from the mount by sliding the cover
forward.
2. Slide the optional drop tank (B) into the rail (C) on the bottom of
the fuselage.
Check the Center of Gravity with the drop tank installed.
See the Adjusting the Center of Gravity instructions for more information.
Disassemble in reverse order.

Propeller Installation

WARNING: Do not install the propeller until all system setups are
complete. Failure to heed this warning could result in severe personal
injury.
1. Install the aluminum backplate (D) into the back of the cooling fan
hub (B).
2. Install the 3 propeller blades (A) onto the cooling fan hub using 6 screws
(M3 x 16mm) (C).
TIP: The propeller's beveled screw holes must face out from the cooling fan
hub for correct operation.
TIP: Before installing the cooling fan hub, be sure the ESC wires do not
interfere with the cooling fan blades.Tuck the ESC wires into the ESC opening
away from the cooling fan blades.
3. Slide the propeller cooling fan hub assembly onto the propeller shaft (E).
Make sure the hex of the cooling fan hub properly seats on the hex of the
prop shaft.
4. Install the propeller washer (F) and propeller nut (G) onto the propeller
shaft. Secure the propeller cooling fan hub assembly to the prop shaft with
wrench. Important to seat the propeller cooling fan hub assembly on the
hex of the propeller shaft.
5. Align the spinner (H) on the propeller cooling fan assembly. Secure with
screw (M3 x 32) (I). Note; take care not to overtighten the spinner screw
and deform the spinner.
A
B
A
C
F
G
H
I
C
M3 x 16mm
Countersunk Machine Screw
C
E
B
D
I
M3 x 32mm
Countersunk Machine Screw
EN
7