Battery Installation and ESC Arming
Battery Selection
We recommend the 5000mAh 22.2V 6S 30C Li-Po battery (SPMX50006S30).
Refer to the Optional Parts List for other recommended batteries. If using
a battery other than those listed, the battery should be within the range of
capacity, dimensions and weight of the Spektrum Smart Li-Po battery packs to
fit in the fuselage. Be sure the model balances at the recommended CG.
1. Lower the throttle to the lowest settings. Power on the Transmitter, then
wait 5 seconds.
2. Slide the canopy latch back and lift the back of the canopy (A) to remove.
3. Slide the battery tray (B) out of the battery compartment.
4. For added security apply the loop side (soft side) of the optional hook and loop
tape (C) to the bottom of your battery and the hook side to the battery tray.
5. Install a fully charged battery (D) on the front edge of the battery tray as
shown and secure it using the hook and loop straps (E).
TIP: With most 6S 5000mAh 30C LiPo battery packs, install the battery far
forward in the battery tray. Battery will over-hang the front of battery tray and
be near the back face of the firewall.
6. Align the battery tray with the tracks in the battery compartment and slide
the tray all the way forward until the tray locks.
7. Connect the battery to the ESC (the ESC is now armed).
8. Keep the aircraft immobile and away from wind or the system will not
initialize.
• The ESC will sound a series of tones (refer to step 6 of the binding
instructions for more information).
• An LED will light on the receiver.
If the ESC sounds a continuous double beep after the flight battery is
connected, recharge or replace the battery.
9. Reinstall the canopy hatch.
WARNING: Always keep hands away from the propeller. When armed,
the motor will turn the propeller in response to any throttle
movement.
WARNING: If your transmitter supports it, always engage throttle cut
before approaching the aircraft any time a battery is connected.
A
C
B
Optional
E
EN
D
9