Model Assembly; Landing Gear Installation - Horizon Hobby E-FLITE Turbo Timber Evolution 1.5m Manuel D'utilisation

aircraft or perform maintenance of any kind without removing the propeller or engaging throttle cut. Serious injury
could result if the motor starts inadvertently with the propeller still attached.

Model Assembly

Landing Gear Installation

Mount the Landing Gear to the Fuselage
1. Remove the spring clamp assembly and set it aside.
2. Insert the left landing gear assembly into the pocket on the side of the
fuselage as shown. The landing gear legs mount to the flat spot of the
aluminum block which can pivot in the pocket.
3. Thread the included M2.5 x 10mm machine screws through the landing gear
leg into the threaded holes in the aluminum pivot block.
4. Repeat the process to install the right landing gear assembly.
Mount the Spring Assemblies to the Fuselage
1. Align the spring assemblies with the mounting holes in the fuselage. These
assemblies mount to the plastic bracket pre-installed in the fuselage between
the landing gear.
2. Install the two 3 x 10mm self tapping screws to anchor the spring assemblies
in place.
WARNING: Assemble the aircraft, program your radio control system, bind the aircraft, and verify correct
operation before installing the propeller. Never attempt to program the radio components, assemble the
3 x 10mm
self-tapping
button head
Clamp the Spring Assemblies Together
1. Align the spring assemblies with the joiner bracket.
2. Clamp the assembly together with the two 2 x 6mm self tapping screws.
EN
M2.5 x 10mm button
head machine
2 x 6mm
self-tapping
button head
5