Menu; Menu Functions; Off Course Alarm (St1); Damping (St2) - Vetus EC Manuel D'utilisation Et Instructions D'installation

4

Menu

4.1 Menu functions:
To access the menu you have to press
the button. Every time the
button is pressed the next/previous
menu item is shown, press
the menu.
- Course alarm
- Damping
- Display layout
- Key sound
- Contrast
- Calibration
- Align compass St 7
- Variation
- Close menu
4.1.1 Off course alarm (ST1)
The Off Course Alarm can be set for a
number of degrees off course for both
sides of the course to be steered.
The buzzer inside the unit will sound as
the course is beyond the limits of the off
course setting.
• Press in default mode to enter the
menu.
• Press again to enter the Off
Course Alarm Menu (ST1).
• Use the /
preferred course.
• Press and enter the Portside
alarm limit with the
tons. This can be set from 2 to 45
degrees difference.
• Press and enter the Starboard
alarm limit with the
tons. This can be set from 2 to 45
degrees difference.
• Keep pressed for two seconds
to exit to the default mode.
Electronic Compass EC
/
to enter
St 1
St 2
St 3
St 4
St 5
St 6
St 8
buttons to set the
/ but-
/ but-
Example:
If the 'Set course' is 246, the 'Limit port-
side' set to 3 and the 'Limit starboard' is
set to 2, then the alarm will sound if the
course change is less than 246-3 = 243
and if the course is more than 246+2 =
248 degrees.
Use the button in the default mode
to set the Alarm ON or OFF (see 3.4).
4.1.2 Damping (ST2)
Damping allows you to change the damp-
ing level as conditions change. The damp-
ing controls the averaging period over
which the heading is displayed. Damping
does not make the compass less accu-
rate, only slower. Damping levels can be
set from Off and 1 up to 7. In normal con-
ditions level 2 is used.
• Press in the default mode to enter
menu.
• Press the /
the Damping menu (ST2).
• Press to enter the Damping
menu.
• Use the /
the value.
• Press short to enter the select-
ed value or
• Press the
value to default (2) or
• Keep pressed for two seconds
to exit to the default mode.
ENGLISH
buttons to select
buttons to change
button to reset the
17
100505.01