Variation (St8); Error Messages; Service Menu; Display Info - Vetus EC Manuel D'utilisation Et Instructions D'installation

4.1.8 Variation (ST8)
The Variation can be set to compensate
the magnetic heading so that the display
shows the geograpical (True) heading.
• Press in the default mode to enter
the menu.
• Use the /
the Variation menu (ST8).
• Press to enter the Variation
menu.
• Use the /
offset. This can be set in steps of 0.1°
up to +/- 45°.
• Press to return to the menu or
• Keep pressed for two seconds
to exit to the default mode.
Use the up button in the default mode to
select True or Mag. Display (see 3.5).
4.1.9 Error messages
No data input:
The electronic compass has not received
data for more than 5 seconds.
- Check the connections.
No response:
No response after send a command:
- Check the connections or another not
fully compatible compass is connected.
20
100505.01
buttons to select
buttons to set the
4.2 Service menu
To enter the service menu you have to
press when you switch the power
on.
4.2.1 Display info
Press to view: Display type, interface,
software version.
4.2.2 Compass info
Press to view: Compass type, inter-
face, software version.
4.2.3 Display reset
Press to reset the display to factory
settings.
4.2.4 Compass reset
Press to reset the compass to factory
settings.
4.2.5 Close menu
To exit the service menu press .
Electronic Compass EC