Jenn-Air PRO-STYLE JGRP430 Instructions D'installation page 25

2. Pull the broil burner toward you until it slides out of the hole in
the oven back, and pull the electrode out of the bracket. The
broil burner will hang down in the back of the oven while you
change the orifice.
A. Grasp electrode here.
B. Bracket
3. Apply masking tape to the end of a 7 mm nut driver to help
hold the gas orifice spud in the nut driver while changing it.
Insert nut driver into the gas opening and press down onto
the gas orifice spud and remove by turning the gas orifice
spud counterclockwise and lifting out. Set gas orifice spud
aside.
A B
A. Oven back
B. Broil burner orifice
C. Broil burner orifice hole
4. Gas orifice studs are stamped with a letter and a number.
Install the Number 148 oven broil burner orifice spud.
5. Place LP gas orifice in plastic parts bag for future use and
keep with package containing literature.
C
6. Replace the broil burner in the hole in the oven back, with the
broil burner electrode inside the broil burner electrode hole,
as illustrated.
A
B
7. Reinstall the oven broil burner screw. See Step 1 for
illustration.
To Convert Oven Bake Burner (Left Oven Cavity on
48" [121.9 cm] models)
1. Remove oven racks.
2. Remove the oven door. See the "Oven Door" section in the
Use and Care Guide.
3. Slide the bake burner cover to the right or left.
A
4. Lift up and remove oven bake burner cover and set aside.
A
A. Broil burner orifice hole
B. Broil burner electrode
C. Broil burner electrode hole
A. Bake burner cover
B C
25