Jenn-Air PRO-STYLE JGRP430 Instructions D'installation page 22

Masquer les pouces Voir aussi pour PRO-STYLE JGRP430:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6. Turn over the gas pressure regulator cap and reinstall on the
regulator so that the hollow end faces out and the letters
"NAT" are visible.
7. Tighten the gas pressure regulator cap by using a large flat-
blade screwdriver, turning the regulator cap clockwise.
8. Test the gas pressure regulator and gas supply line.
The regulator must be checked at a minimum 1" (2.5 cm)
water column above the set pressure. The inlet pressure to
the regulator should be as follows for operation and checking
the regulator setting:
Natural Gas:
Minimum pressure 6" (15.2 cm) WCP
Maximum pressure 14" (35.6 cm) WCP.
Gas Supply Pressure Testing
Gas supply pressure for testing regulator must be at least
1" water column pressure above the manifold pressure
shown on the model/serial rating plate.
Line pressure testing above ½ psi gauge (14" WCP)
The range and its individual shutoff valve must be
disconnected from the gas supply piping system during any
pressure testing of that system at test pressures in excess of
½ psi (3.5 kPa).
Line pressure testing at ½ psi gauge (14" WCP) or lower
The range must be isolated from the gas supply piping
system by closing its individual manual shutoff valve during
any pressure testing of the gas supply piping system at test
pressures equal to or less than ½ psi (3.5 kPa).
To Convert Oven Bake Burner (30" [76.2 cm] and 36"
[91.4 cm] models and the Right Oven Cavity on 48"
[121.9 cm] models)
1. Remove oven racks and the extendable roller rack from
inside the oven cavity. See the "Extendable Roller Rack"
section in the Use and Care Guide.
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven
doors.
Failure to do so can result in back or other injury.
2. Remove the oven door. See the "Oven Door" section in the
Use and Care Guide.
22
3. Slide the bake burner cover to the right or left.
A
A. Bake burner cover
4. Lift up and remove oven bake burner cover and set aside.
5. Unscrew oven baffle nuts and remove oven baffle. Set aside.
A. Oven baffle
B. Oven baffle nuts
A
B

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pro-style jgrp436Pro-style jgrp536Pro-style jgrp548

Table des Matières