Care & Maintenance - PRO-POINT 8844029 Mode D'emploi

8844029
area. Do not press down too hard, as this can cause the wheel to slow
or gouge the workpiece.
11. Lift the angle grinder from the material and slowly release the trigger
lever. The trigger lever safety will automatically snap back into place.
12. Wait for the wheel to stop before placing the tool down.
13. Shut the compressor off once the task is completed. Squeeze the trigger
to release residual compressed air from the hose and tool. Disconnect
the tool.
WHEELS AND ACCESSORIES
Angle grinder wheels and accessories are designed to cut, polish and
shape surfaces. Some wheels can be used on any material while others
are designed specifically for wood, plastic or metal.
Check the wheel facing for information on grit, arbor size, disc diameter,
max. speed and coating type.
Flap disc
Wire wheel or cup Surface preparation, paint and rust removal.
Polishing disc
Sanding Wheel
Grinding Wheel
Cutting wheel
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2. Inspect the tool fittings, alignment and hoses periodically. Have damaged
or worn components repaired or replaced by an authorized technician.
Only use identical replacement parts when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool clean, dry and free from oil/grease at all times.
12
5 in. Air Angle Grinder
Metal removal and finishing. Available in different grits.
Polish metal. Different disc materials available for
different types of polishing compounds.
Material removal of non-ferrous metals, steel and
aluminum.
Material removal of stone, concrete, tile or metal.
Available in different grits.
Cut through metal or masonry, stone, tile and concrete.
Available in different grits.
For technical questions call 1-800-665-8685
V1.0