PRO-POINT 8844029 Mode D'emploi page 13

V1.0
6. Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
7. Keep the vent passages clear of accumulated dirt, dust, and oil.
8. Clean the tool after each use.
WARNING! Only qualified service personnel should repair the tool.
An improperly repaired tool may present a hazard to the user
and/or others.
AIR TOOL LUBRICATION
NOTICE! Only use air tool oil to lubricate the tool. Other lubricants
are not suitable and will damage the tool or cause a malfunction
during use.
NOTICE! Never use a penetrating oil to lubricate an air tool.
Penetrating oil acts as a solvent that will dissolve the tool's grease
packing and may damage the o-rings, causing the tool to seize or
malfunction.
1. All air tools have an internal coating of grease to prevent corrosion
during shipping and storage. Remove this grease by adding a
generous amount of air tool oil in the air inlet and then run the tool
under no load until the exhaust is clear.
2. Manually add a drop or two of air tool oil into the tool's male coupler
before each use and after every hour of continuous use. The tool will
not work properly without lubrication and parts will wear prematurely.
3. Avoid adding too much air tool oil as this can cause premature power
loss and eventual tool failure. A qualified technician will need to take
the tool apart and clean out the excess oil.
4. Apply a generous amount of air tool oil to the tool before storing it for
an extended period of time (overnight, weekend, etc.). Run the tool for
approximately 30 seconds to ensure the oil is evenly distributed
throughout the tool. Store it in a clean and dry location.
GREASE THE SPINDLE GEAR ASSEMBLY
Greasing the spindle gear assembly is recommended to extend the tool's
life. Remove the screw (#25) in the front. Insert a grease gun nozzle into
the opening and squeeze several drops of grease into the head. Re-install
the screw, then run the tool for several moments to distribute the grease.
Visit www.princessauto.com for more information
5 in. Air Angle Grinder 8844029
13