Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8844243
DIES AND ATTACHMENTS
Die grinder dies and attachments are designed to cut, polish and shape
surfaces. Some attachments can be used on any material while others
are designed specifically for wood, plastic or metal. Consult the
manufacturer's information to determine the correct use of the die or
attachment.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient,
easier to control and will have fewer problems.
2.
Inspect the tool fittings, alignment, hoses and power supply cord
periodically. Have damaged or worn components repaired or
replaced by an authorized technician. Only use identical
replacement parts when servicing.
3.
Verify the die grinder's speed with a tachometer to ensure it does
not exceed the maximum speed. Have the tool repaired if the max.
speed is higher than the no load speed in Specifications.
4.
Follow instructions for lubricating and changing accessories.
5.
Only use accessories intended for use with this tool.
6.
Keep the tool handles clean, dry and free from oil/grease at all times.
7.
Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
8.
Keep the vent passages clear of accumulated dirt, dust, and oil.
9.
Clean the tool after each use.
WARNING! Only qualified service personnel should repair the
tool. An improperly repaired tool may present a hazard to the
user and/or others.
12
Low-Noise Air Die Grinder
For technical questions call 1-800-665-8685
V1.0
Publicité
Table des Matières
