Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
INSTALL THE GRINDING WHEEL
Accessories such as specialty wheels are installed in the same manner as
a grinding wheel.
1.
Insert the wrench (#32) behind the rear flange nut to hold the spindle
(#25) by the flat sections.
2.
Insert the pin wrench (#33) pins into the front flange nut openings.
Turn the wrench clockwise to loosen the nut.
3.
Remove the front flange nut (#30 from the spindle.
4.
Mount a 5 in. grinding wheel onto the spindle. Make sure the wheel is
properly oriented with the printed face against the angle grinder.
5.
Screw the flange nut onto the spindle. Tighten with the wrench and pin
wrench by turning counterclockwise.
OPERATION
1.
Clean the angle grinder of packing grease before first use. Also
grease the spindle gears. See the Air Tool Lubrication section for
instructions.
2.
Loosen the wheel guard by pulling the small lever (#26) inside the wheel
guard. Rotate the wheel guard to the left or right to maximize user
protection when grinding. Push the small lever to lock the wheel guard
in place.
3.
Install the grinding wheel (See Assembly & Installation). The type of
grinding wheel installed will depend on the material and task.
4.
Connect the tool to the air source.
5.
Set the compressor to the correct air pressure and flow (see
Specifications). Start the compressor.
6.
Hold the angle grinder by the handle (C) and rear body.
7.
Push the trigger lever safety (D) forward to free the trigger lever (E).
8.
Squeeze and hold the trigger lever to increase the grinding wheel
speed. Wait until the wheel has reach full speed before applying it to
the material
9.
Test the tool under no load to confirm the grinding wheel is installed
correctly.
10. Hold the angle grinder and apply the leading edge of the grinding
wheel against the material, so the debris is moved away from the work
Visit www.princessauto.com for more information
5 in. Air Angle Grinder
8844029
11
Publicité
Table des Matières
