Assembly & Installation - PRO-POINT 8844029 Mode D'emploi

8844029
Remove the parts and accessories from the packaging and inspect for
damage. Make sure that all items in the contents are included.
Contents: • Air Angle Grinder • Wheel Guard
• Wrench x 2
IDENTIFICATION KEY
A Flange Nut
B Wheel Guard
C Handle
D Trigger Lever Safety
E Trigger Lever
F Air Inlet
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
Letter references in parenthesis (A) refer to the included Identification Key
INSTALL AIR PLUG
Prepare a standard 1/4 in. NPT male air plug (sold separately) for use with
your tool.
1. Wrap the external threads of the male plug with sealant tape.
1.1 Wrap tape in a clockwise direction so it will not unravel.
1.2 Do not tape all the threads. Leave several leading threads
unwrapped for easier alignment.
2. Screw the plug into the tool's air inlet and tighten with a wrench until snug.
3. Run the compressor at a low volume and check the connection for air
leaks. Do not use the tool until all air leaks are repaired or the faulty
component is replaced.
IMPORTANT! Vibration may cause failure if a quick coupler is
connected directly to the air tool. To overcome this, connect a
leader hose to the tool. A quick coupler may then be used to
connect the leader hose to the air line hose.
10
5 in. Air Angle Grinder
For technical questions call 1-800-665-8685
• Handle
V1.0