PRO-POINT 8844029 Mode D'emploi page 14

8844029
STORAGE
When not in use for an extended period, apply a thin coat of lubricant to
the steel parts to avoid rust. Remove the lubricant before using the tool
again.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-laws for
electronic devices, batteries, oil or other toxic liquids.
IMPORTANT! DO NOT pollute the environment by allowing
uncontrolled discharge of waste oil.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified
technician service the tool.
PROBLEM(S)
Tool runs at
normal speed, but
loses power under
load.
Tool runs slowly.
Air flows slightly
from exhaust.
Tool runs slowly.
Air flows slightly
from exhaust.
14
5 in. Air Angle Grinder
POSSIBLE CAUSE(S)
Motor parts worn.
Motor parts jammed
with dirt particles.
OR
Airflow blocked by dirt.
Air regulator in closed
position.
SUGGESTED SOLUTION(S)
1. Have a qualified technician
service the tool.
2. Replace tool or parts.
1. Check air inlet filter for
blockage.
2. Pour air tool lubricating oil
into air inlet as per
lubrication instructions for
clearing shipping grease.
3. Operate tool in short bursts
to clear debris.
4. If tool still jammed, clean
tool and lubricate per
lubrication instructions.
Open the air regulator to
desired airflow.
For technical questions call 1-800-665-8685
V1.0