Pressure Drop; Care & Maintenance - PRO-POINT 9029893 Mode D'emploi

9029893
CAUTION! Always check the grinding attachment for tightness
before each use. A loose attachment can be thrown from the tool
with considerable force, causing injury.
OPERATION
1. Connect the tool to the air hose.
2. Place the grinding attachment over the work piece and turn on the
air die grinder.
IMPORTANT! Use grinding wheels when working with hard
materials and rotary files for milling soft materials such as
nonferrous metals (aluminum, brass, copper, etc.) Using grinding
wheels when working with soft materials will clog the wheel,
preventing it from cutting as it was designed.
NOTICE! Do not allow the tool to run with no load for an extended
period of time as this will shorten its life.

PRESSURE DROP

Apply the air consumption and pressure rate numbers to the tool's air
inlet, not the compressor's outlet. Calculate the pressure drop for your
air supply set-up and increase the compressor outlet pressure to
compensate. Make sure you do not exceed the maximum pressure for
any part of your air supply system.
Installing a pressure gauge at the tool inlet is the best way to measure
the air pressure and adjust the compressor's output.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient,
easier to control and will have fewer problems.
2. Inspect the tool fittings, alignment, hoses and power supply cord
periodically. Have damaged or worn components repaired or replaced
by an authorized technician. Only use identical replacement parts
when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool clean, dry and free from oil/grease at all times.
10
1/4 in. Extended Air Die Grinder
For technical questions call 1-800-665-8685
V1.0