Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8844243
Remove the parts and accessories from the packaging and inspect for
damage. Make sure that all items in the contents are included.
Contents:
• Air Die Grinder
• 14 mm Wrench
IDENTIFICATION KEY
A
Collet
B
Collet Nut
C
Spindle
D
Trigger Lever
E
Trigger Lever Safety
F
Air Regulator
G
Air Inlet
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
Letter references in parenthesis (A) refer to the included Identification Key
INSTALL AIR COUPLER
Prepare a standard 1/4 in. NPT male air coupler (sold separately) for
use with your tool.
1.
Wrap the external threads of the male coupler with sealant tape.
1.1 Wrap tape in a clockwise direction so it will not unravel.
1.2 Do not tape all the threads. Leave several leading threads
unwrapped for easier alignment.
2.
Screw the coupler into the tool's air inlet and tighten with a wrench
until snug.
3.
Run the compressor at a low volume and check the connection for
air leaks. Do not use the tool until all air leaks are repaired or the
faulty component is replaced.
IMPORTANT! Vibration may cause failure if a quick coupler is
connected directly to the air tool. To overcome this, connect a
leader hose to the tool. A quick coupler may then be used to
connect the leader hose to the air line hose.
10
Low-Noise Air Die Grinder
• 19 mm Wrench
• Male Plug
For technical questions call 1-800-665-8685
V1.0
Publicité
Table des Matières
