Assembly & Installation - PRO-POINT 9029893 Mode D'emploi

V1.0
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace
the missing part before operating. Failure to do so could result in
a malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect
for damage. Make sure that all items in the parts list are included.
ASSEMBLY & INSTALLATION
INSTALL AIR COUPLER PLUG
Prepare a standard 1/4 in. NPT coupler plug (sold separately) for use
with your tool.
1. Wrap the external threads of the coupler plug with sealant tape.
a. Wrap tape in a clockwise direction so it will not unravel.
b. Do not tape all the threads. Leave several leading threads
unwrapped for easier alignment.
2. Screw the coupler plug into the tool's air inlet and tighten with a
wrench until snug.
3. Run the compressor at a low volume and check the connection for
air leaks. Do not use the tool until all air leaks are repaired or the
faulty component is replaced.
IMPORTANT! Vibration may cause failure if a quick coupler is
connected directly to the air tool. To overcome this, connect a
leader hose to the tool. A quick coupler may then be used to
connect the leader hose to the air line hose.
INSTALL GRINDING ATTACHMENT
1. Select the appropriate grinding attachment for the task.
2. Push the spanner in the collet shaft.
3. Insert the mandrel into the collet chuck a minimum of 1/4 in. deep
to prevent the attachment from disengaging from the grinder while
in use.
4. Tighten the collet chuck securely with the spanner.
Please read and understand all instructions before use. Retain this manual for future reference.
9029893