KONG Italy Q.R.K. Mode D'emploi page 15

3.2 INSPECTION PRIOR TO DELIVERY - I.P.D.
This inspection must be carried out each
time the Q.R.K. leaves the stores to be
assigned to the user, another Department,
or another Body. This must be done as
follows:
a) Visually inspect it, looking for any
damage, dirt, stains, oil, etc.
b) Check that the components that make
up the system are in place and integral:
- The device is properly clean.
- The safety clip is in its place and has
not been deformed.
- The opening mechanism is working
properly, by doing a trial release.
- The closing mechanism is working
properly, by doing a trial reset.
PLEASE NOTE
If even only one of the problems indicated
in points a) and b) above occurs, the Kit
must be sent back to the E.I. along with
a document that indicates the type of
problem encountered.
c) If no problems are found, the Q.R.K. is
put back into its packaging and sent to
whoever has requested it.
www.kong.it
NOTE:
New packaging must clearly indicate
all the details provided on the original
packaging.
The Inspection Prior to Delivery must be
recorded in the Identity Handbook.
WARNING
The date of first use must be recorded in
the Identity Handbook, and will be used
to determine the Kit's lifespan, as per
paragraph 3.6.
Q.R.K. Quick Release Kong
15