Safety - Cooke & Lewis CLMIRAG90-C Mode D'emploi

Safety

Cooker Hood
GB IE
These instructions are for your safety. Please read through
them thoroughly prior to installation and retain them for
future reference.
All installation work must be carried out by a competent
person or qualified electrician.
The appliance is for domestic use only.
Please dispose of the packing material carefully.
Warning: consult local regulations regarding fumes outlets.
Do not connect the hood to a fume, ventilation or hot air
duct.
Confirm that room ventilation is appropriate with the local
authorities.
Make sure the maximum air extraction flow rate for the
appliances in the room does not exceed 4 Pa (0.04 mbar).
The room must have adequate ventilation if an extractor
hood is used simultaneously with appliances that run on
gas or other fuels.
The evacuated air must be extracted through ducts that are
used for evacuating fumes from appliances that run on gas
or other fuels.
Regulations regarding air extraction must be complied with.
Warning: before connecting the hood: switch off the
electricity supply and check that the supplied voltage and
frequency coincide with that indicated on the appliance
nameplate.
Warning: the hood may stop working during an
electrostatic discharge (e. g. lightning). This involves no risk
of damage. Switch off the electricity supply to the hood and
reconnect after one minute.
Means for disconnection must be incorporated in the fixed
wiring in accordance with the wiring rules. An all-pole
disconnection switch having a contact separation of at least
3mm in all poles should be connected in fixed wiring.
This appliance is not intended for use by persons
(including children) with reduced physical sensory, or
mental capabilities, or by those who lack experience and
knowledge, unless they have been given supervision and
instruction concerning the use of the appliance by a person
responsible for their safety.
8
CLMIRAG90-C-Cooke & Lewis-IM-GB-FR-01.indb 8 1/1/12 12:31 AM