Table des Matières
Publicité
To Ensure Safe Use
Danger of electrical short, shock, electrocution, or fire
This machine carries a high current of a maximum of approximately 9 amperes. This can cause
situations that could not occur with low-power equipment; use caution.
WARNING
Before switching on the power, set the
voltage switch to match the voltage of the
region where the unit is used.
When set incorrectly, the machine may fail to
operate normally. The temperature of the print
heater and dryer may rise to undue levels, which
may result in fire, or the temperature may fail to
rise at the correct speed.
Do not use with any electrical power sup-
ply that does not meet the ratings dis-
played on the unit.
Use with any other power supply may lead to
fire or electrocution.
Never operate the machine or insert or
remove its power plug with wet hands.
Doing so may result in electrical shock or elec-
trocution.
Never allow the machine to get wet, or
apply gasoline, thinner, or any other flam-
mable material to it.
Current leakage may cause electrical shock, elec-
trocution, or combustion and fire.
Never allow hairpins, coins, matches, or
any other object to get inside the machine
through the ventilation ports.
Doing so may cause and electrical short, result-
ing in shock or electrocution, or the inserted
object may catch fire.
Never place gasoline, alcohol, thinner, or
any other flammable material near the
machine, or use an aerosol spray close to
the machine.
Doing so may cause fire.
Never damage the power cord or pull it
with force.
Doing so may tear the cord's insulation, causing
an electrical short and resulting in electrical
shock, electrocution, or fire.
6
Never place any object on the power cord,
bend the power cord using excessive force,
or allow the power cord to become de-
formed.
If it becomes deformed, the deformed location
may grow hot and cause fire.
Never use the machine with the power
cord bound into a bundle or roll.
If the cord is in a bundle or roll, it may grow hot
and cause fire.
Never use any power cord other than the
power cord included with the machine.
Also, never use a power strip or extension
cord.
The power strip or extension cord may grow
hot and cause fire.
Do not use with a damaged power cord
or plug, or with a loose electrical outlet.
Doing so may lead to fire, electrical shock, or
electrocution.
When unplugging the electrical power
cord from the power outlet, grasp the plug,
not the cord.
Unplugging by pulling the cord may damage it,
leading to fire, electrical shock, or electrocution.
Ground the unit with the ground wire.
Failure to do so may result in risk of electrocu-
tion in the event of a mechanical problem.
In the event of an abnormal state (such as
smoke or sparks, odor or burning or un-
usual noise), immediately unplug the
power cord.
Failure to do so may result in fire, electrical
shock, or electrocution. Immediately disconnect
the power cord and contact your Roland DG
Corp. service center.
Publicité
Table des Matières
