CF MOTO CFORCE 1000 Guide De L'utilisateur page 58

2 Headlight Switch
The headlight switch consists of 4 positions:
: When the switch is at this position, Hi beam, front position
light, tail light, and license plate light are on.
: When the switch is at this position, Lo beam, front position light
, tail light, and license plate light are on.
OFF: When the switch is at this position, only daytime running light
is on and all other lights are off �
: When the switch is at this position,daytime running light, tail
light, and front position light are on.
3 Turn Switch (If equipped)
Move the switch to
Move the switch to
4 Hazard Switch (If equipped)
Press the button . Front turn lights, rear turn lights and turn
signal indicators on dashboard flash.
CAUTION
Do not use the headlights with the engine turned off for more than
15 minutes. The battery may discharge to the point that the starter
motor will not operate properly. If this should happen, remove the
battery and recharge it.
FEATURES & CONTROLS
for left turn signal indicator on.
for right turn signal indicator on.
3
54
2
4