CF MOTO CFORCE 1000 Guide De L'utilisateur page 143

Front gear case oil check
1. Place the vehicle on a level surface.
2. Remove the oil filler plug
should be up to the brim of the hole. If the level is low, add
sufficient oil to raise it to the specified level.
3. Install the oil filler plug and tighten it to the specified torque.
NOTE: Oil filler plug tightening torque: 25 N•m (18.4 ft-lb.)
Front gear case oil change
1� Place the vehicle on a level surface.
2� Place a container under the front gear case to catch the oil.
3� Remove oil filler plug
used oil.
4� Install the drain bolt and tighten it to the specified torque.
5� Fill the front gear case with oil�
6� Install the filler plug and tighten it to the specified torque.
7� Check for oil leaks. If oil leakage is found, find and repair it.
NOTE:
Drain bolt torque: 25 N•m (18.4 ft-lb.)
Periodic oil change: 230 ml (7.7 oz.)
NOTE: Be sure no foreign material enters the gear case.
MAINTENANCE
1
and check the oil level. The level
and drain bolt as shown, and drain
1 2
139
1
2