Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
NOTE: Specified spark plug:DCPR8E (NGK)
Installation
Measure the electrode gap with a wire thickness gauge and, if
necessary, adjust the gap to specifications.
a
NOTE: Spark plug gap
: 0.8 mm~0.9 mm
a
1� Clean the gasket surface. Wipe off any grime from the threads.
2� Install spark plug and tighten to specified torque.
NOTE: Tightening torque of spark plug: 14.8 ft-lb. (20N•m)
If a torque wrench is not available when you are installing a spark
plug, a good estimate of the correct torque is 1/4 to 1/2 turn past
finger tight. Have the spark plug tightened to the specified torque
as soon as possible.
3� Install the spark plug cap.
4� Install the panel�
146
Publicité
