CF MOTO CFORCE 1000 Guide De L'utilisateur page 138

Oil filter replacement
1� Use wrench to unscrew bolts
remove oil filter
3
NOTE: Confirm cover O-ring
the crankcase correctly�
2� Install new oil filter
the specified torque.
NOTE: Cover Bolt Torque: 10 N•m
1
3� If not already installed, install a new drain bolt washer and
tighten the oil drain bolt to the specified torque.
NOTE: Drain Bolt Torque: 25 N•m
4� Add the specified amount of recommended engine oil, and
then insert the engine oil dipstick and tighten it�
NOTE:
With oil filter cartridge replacement, oil added: 2.5L
5� Start the engine and warm it up for several minutes. While
warming up,check for oil leaks. If an oil leak is found, turn the
engine off immediately and check for the cause.
6� Turn the engine off. Recheck the oil level and correct it if
necessary�
� Then remove cover
1
�
is good, then install it into groove of
4
and use wrench to tighten cover bolts to
3
MAINTENANCE
and
2
134
1
2
3
4