Software Installation - Analog way SMART FADE SMF251 Manuel Utilisateur

SMART FADE™
9-1. CONNECTION (continued)
• PIN-OUT:
PIN #
2
3
5
8
(Rear panel of the SMART FADE
• SPEED TRANSMISSION: 9600 bauds, 8 data bits, 1 stop bit, no parity bit, no flow control.
9-2. "SMART FADE
Your SMART FADE
CONTROL" software (3.5" disk). This software allows you to control and make adjustments by a simple mouse click
(output format, image adjustments, etc...).

• SOFTWARE INSTALLATION:

Turn your computer ON and wait for WINDOWS to completely start.
Insert the disk into the floppy drive.
In the WINDOWS START menu, click on RUN.
Choose the disk drive and click on setup.exe (ex : A:\setup.exe if disk 3.5" is drive A).
Follow the WINDOWS installation instructions. WINDOWS will create a file C:\Programfiles\ANALOGWAY\
SMART FADE remote control.
• STARTING UP:
Connect the RS-232 cables between the control device and the SMART FADE
Then only power ON all of the devices.
Click on the program files SMF251 in Start-program-ANALOGWAY-SMART FADE to run the software.
Click on Control menu and select the Serial port.
The SMART FADE
selected serial port).
FUNCTIONS
TRANSMIT DATA (Tx)
RECEIVE DATA (Rx)
GROUND (Gnd)
+12 Vdc (power of the RK251)
DB 9 female
™
REMOTE CONTROL" SOFTWARE
™
is shipped with a WINDOWS 95/98/2000/Me/XP compatible "SMART FADE
™
is now connected to the computer (if not, verify the DB9 serial connection and the
™
)
Chapter 9 : CONTROL SOFTWARE
™
REMOTE
™
as indicated in section 9-1.
PAGE 27