Analog way SMART FADE SMF251 Manuel Utilisateur page 37

SMART FADE™
10-5. COMMANDS DESCRIPTION (continued)
IMAGE COMMANDS
The following commands are active only on the selected (displayed) video input.
They are not active for the COMPUTER input.
•
H, V, W, S, B, C, s, T, commands are used to control the output adjustments.
0 = minimum
255 = maximum
•
f command is used to select the image process.
DECIMAL
VALUE
0
1
2
3
4
5
6
7
•
b command is used to select the video input's aspect ratio.
DECIMAL
VALUE
0
1
2
EFFECT COMMANDS
• Y command is used for the CUT, the FADE, and the TITLE action.
Please see the Miscellaneous Commands section.
Ex.: To do a CUT, type 1Y, if all of the other bits of the Y command are 0.
• @ command is used to do a MANUAL FADE effect.
Ex. : Type @ to read the current value of the MANUAL FADE.
If the read starting value is 0 then type a value between 1 and 100 (ex. : type 75@).
If the read starting value is 100 then type a value between 99 and 0 (ex. : type 25@).
• ~ command is used to select the delay of the automatic FADE effect.
The value of the delay can be between 1 and 255 (1 = 0.1 Sec., 255 = 25.5 Sec.).
Ex. : Type 5~ to select 0.5 Sec. Fading time
Type 10~ to select 1 Sec. Fading time
Type 20~ to select 2 Sec. Fading time
Type 30~ to select 3 Sec. Fading time
Type 40~ to select 4 Sec. Fading time
Type 50~ to select 5 Sec. Fading time
To activate the automatic FADE , use the Y command.
SELECTION (IMAGE PROCESS)
NO PROCESS
SHARPNESS 1
SHARPNESS 2
SHARPNESS 3
GAMMA 1
GAMMA 2
SHARPNESS 1 + GAMMA 1
SHARPNESS 2 + GAMMA 1
SELECTION OF ASPECT RATIO
4/3
14/9
16/9
Chapter 10 : RS-232 PROGRAMMER'S GUIDE
RESPONSE APPLICATION
SHARP0
SHARP1
SHARP2
SHARP3
SHARP4
SHARP5
SHARP6
SHARP7
RESPONSE APPLICATION
IASP0
IASP1
IASP2
ALL
ALL
PAGE 37