Vortice VORT HRW 30 MONO EVO Livret D'instructions page 37

ENGLISH
To disable a function (fig. 28):
1) press the FUNCTION button for more than 2 seconds .
2) press the SPEED button to select one of the three LEDs
(LED 1, LED 2, LED 3) corresponding to the AUTONIGHT /
AUTO HR% / AUTO COMFORT function to be disabled.
3) press the MODE button to disable the function.
4) to SAVE the settings, press the FUNCTION button for more
than 2 seconds. All SPEED LEDs blink 4 TIMES to indicate
correct storage.
5) to CANCEL and exit the setting procedure, press the
FUNCTION key once. All SPEED LEDs blink ONLY ONCE
WITHOUT SAVING any changes made.
6) to CHECK which function is assigned to the appliance, press
the FUNCTION button for more than 2 seconds : : the LED
corresponding to the set function blinks for about 20 seconds,
then all the speed LEDs flash and the device returns to
standard display.
D: FILTER LED (fig. 26B)
A led (D) indicates the status of the filters:
• LED OFF: filters are clean
• LED ON: filters to be cleaned or replaced (for each day of operation, a counter in the memory is increased and when the
maximum preset time is reached (90/180/365 days), the signalling LED lights up).
Refer to section "maintenance and cleaning".
CLOSING OF THE DEVICE
To avoid air to come inside the room, set the device in stand-by mode by pressing the FUNCTION key (LEDs in the SPEED
column switch off) and turn the lever to close position (fig. 29).
29 29
1
2
28 28
LED
EXTRACTION /AUTO COMFORT
LED
INTAKE /AUTO HR%
LED
RECOVERY/AUTO NIGHT
FUNCTION
BUTTON
1
LED 5
LED 4
LED 3
LED 2
LED 1
MODE SPEED
BUTTON BUTTON
3 2
37