Installation - Cooke & Lewis CLFLEX2Z30 Manuel D'installation

Installation

EN Before you start
CAUTION: The induction hob must be installed by qualified personnel or technicians.
• The hob must not be installed directly above a dishwasher, fridge, freezer, washing machine or clothes dryer, as the
humidity may damage the hob electronics.
• Do not attempt to dismantle the appliance, there are no user servicable parts inside.
• At the end of its life, the appliance should not be disposed of in household waste; contact your Local Authority for
guidance.
CAUTION: This hob must be connected to the mains power supply only by a suitably
• Before connecting the hob to the mains power supply, check that:
- The domestic wiring system is suitable for the power drawn by the hob.
- The voltage corresponds to the value given in the rating plate.
- The power supply cable sections can withstand the load specified on the rating plate.
- To connect the hob to the mains power supply, do not use adapters, reducers, or branching devices, as they can
cause overheating and fire.
- The power supply cable must not touch any hot parts and must be positioned so that its temperature will not exceed
75 °C at any point.
- The work surface is square and level, and no structural members interfere with space requirements.
- The work surface is made of a heat-resistant material.
- If the hob is installed above an oven, the oven has a built-in cooling fan.
- The installation will comply with all clearance requirements and applicable standards and regulations. The permanent
wiring, mounted and positioned to comply with the local wiring rules and regulations.
- The isolating switch must be of an approved type and provide a 3 mm air gap contact separation in all poles (or in all
active [phase] conductors if the local wiring rules allow for this variation of the requirements).
- The isolating switch will be easily accessible to the customer with the hob installed.
• You consult local building authorities and by-laws if in doubt regarding installation.
• You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall surfaces surrounding the hob.
• When you have installed the hob, make sure that: The power supply cable is not accessible through cupboard doors or
drawers.
• There is adequate flow of fresh air from outside the cabinetry to the base of the hob.
• If the hob is installed above a drawer or cupboard space, a thermal protection barrier is installed below the base of the
hob.
• The isolating switch is easily accessible by the customer.
• The hob should be fixed into the worktop using the fixing brackets with the supplied assembling screws. This hob must
not be sealed into the worktop, doing so will prevent an engineer removing the appliance to facilitate a repair.
Please never conduct the operation by yourself.
qualified person.
4