SOUNDMASTER PL790 Mode D'emploi page 9

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
CONTENT OF DELIVERY
➢ Main unit
➢ Instruction Manual
➢ Turntable mat
➢ 45 RPM Adaptor
➢ Warranty Sheet
Notes about the record stylus
➢ Record styluses are precision parts, so handle them carefully to avoid bending or damaging
their tips. If a stylus becomes bent or damaged, it might not be able to follow the audio groove
precisely and could damage records or cause another malfunction.
➢ If a stylus becomes dirty, use a commercially available stylus cleaner or similar product to
clean it.
➢ Do not rub the stylus tip forcefully with anything hard. Do not wipe the stylus with thinner or
other chemicals. Doing so could harm it.
CHANGING THE CARTRIDGE
• Connect the wire leads to the new Cartridge terminals.
The wire lead color codes are as below:
White Left channel positive (L+)
Black Left channel negative (L-)
Red Right channel positive (R+)
Black Right Channel negative (R-)
INSTALLING THE TURNTABLE PLATTER
1. Turntable belt and ribbon (pre-installed to the metal platter and
turntable belt)
2. To install the platter on the unit and the belt on the pulley, please
do the following:
a. Position the platter with the cutout over the drive roller.
b. Pull the belt over the drive pulley
ATTACHING THE TURNTABLE COVER
1. Insert the hinges completely into the hinge holders at the left and right ends of the back side
of the main unit.
2. Align the tops of the hinges with the turntable cover hinge holders and insert them.
REMOVING THE TURNTABLE COVER
Hold both edges of the turntable cover and lift it slowly to remove it along with the hinges from
the unit. Then, remove the hinges from the turntable cover.
INSTALLATION
➢ AC-DC Adaptor
➢ Dust cover
➢ Metal platter with belt
➢ Counterweight
2
PL790 / English Instruction Manual
(Black)
(Black)

Publicité

Table des Matières
loading

Table des Matières