KitchenAid 5KSM1CB Mode D'emploi page 20

TROUBLESHOOTING
1. If the digital display is not illuminated:
• Check to see whether the Precise Heat
Mixing Bowl is plugged into a grounded
outlet. If it is, check the fuse or circuit
breaker on the electrical circuit the
bowl is connected to and make sure the
circuit is closed.
2. If all the lights on the digital display
are flashing:
• The Precise Heat Mixing Bowl was not
in place when the Start/Cancel button
was pressed. Check that the bowl is
properly attached for your model of
Stand Mixer.
3. If the display shows "Er1" on the digital
display:
• The Precise Heat Mixing Bowl sensed
that an interruption occured with
the Bowl Temperature Sensor (BTS).
Unplug the bowl and plug back in to
see if that will reset the unit.
If the display shows "Er2" on the
digital display:
• The BTS has sensed an abnormal
temperature. Unplug the Precise Heat
Mixing Bowl and allow it to be brought
to room temperature before plugging
it back in.
20
W10719711A_01_EN_v22.indd 20
4. I f the Temperature indicator flashes
quickly 3 times when selecting the
desired Temperature setting:
• The dial was rotated past the
maximum temperature setting.
Turn dial the other way to reduce
the Temperature selection.
If the problem cannot be corrected using
the steps above, see the "Warranty and
service" section. Do not return the Precise
Heat Mixing Bowl to the retailer; retailers
do not provide service.
C W
11/20/14 9:34 AM