KitchenAid 5KSM1CB Mode D'emploi page 11

ASSEMBLING THE PRECISE HEAT MIXING BOWL
Before first use
Before using your Precise Heat Mixing Bowl
for the first time, wash the stainless steel
bowl liner, lid, and stir accessory with soapy
water, then rinse with clean water and dry.
Do not use abrasive cleaners or scouring
pads.
NOTE: These parts can also be washed
in the top rack of the dishwasher.
Attaching the Precise Heat Mixing Bowl to the Stand Mixer
The Precise Heat Mixing Bowl can either
be used by itself, or attached to your Stand
Mixer with the lid removed. The Precise
Heat Mixing Bowl is compatible with the
following models: 5KSM150, 5KSM156,
5KSM6521, 5KSM7580, 5KSM7591,
5K45SS, and 5KSM7990
Attaching to Bowl-Lift Stand Mixers
(5KSM6521X, 5KSM7580X, 5KSM7591X)
Use the handles to attach the Precise Heat Mixing Bowl to the Stand Mixer.
Be sure the Stand Mixer's speed control
1
is set to 0 and Stand Mixer and Precise
Heat Mixing Bowl are both unplugged.
Place the bowl-lift lever on the Stand
Mixer in the down position.
W10719711A_01_EN_v22.indd 11
The Precise Heat Mixing Bowl can either be
used by itself, or attached to a KitchenAid
Stand Mixer with the lid removed. When
using the Precise Heat Mixing Bowl alone,
see the "Using the Precise Heat Mixing
Bowl" section.
NOTE: When using the Precise Heat
Mixing Bowl by itself, place it on a flat,
level surface.
Before attaching the Precise Heat Mixing
Bowl to a Stand Mixer, decide how to attach
it by determining which model Stand Mixer
you have.
Fit the handles on the Stand Mixer bowl
2
support arms, and press down on the
back of the Precise Heat Mixing Bowl
to snap it into the bowl-lift.
11
11/20/14 9:34 AM