Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Comfort Pure Air™ Bath
Skirt Installation
Bathtubs with an Integral Skirt
Screw skirt flanges into wall studs.
1
It may be necessary to shim the unit to close any
gaps between wall studs and the flanges.
Complete finish work over skirt flange.
2
Caulk around the perimeter of the skirt to seal the
3
space between the skirt and the finished deck.
Bathtubs with Optional Skirt
If you are installing a integral skirt, please refer to the Skirt
Installation Guide before proceeding any further.
Undermount Installation
Install drain/overflow according to the manufacturer's
1
instructions.
Watertight installation of the drain is the installer's
responsibility. Drain leakage is excluded from the Jacuzzi
Luxury Bath warranty of this product.
Turn off power supply to dedicated GFCI protected
2
circuits.
Install the unit in desired location. DO NOT use plumbing
3
fixtures or lines to carry or lower the unit.
Inspect all fittings, plumbing, and control lines after
4
inserting to insure the components are not damaged or
disconnected.
Align the bathtub and connect the drain.
5
Insulation may be placed within the bathtub surround.
6
Provide adequate ventilation around the motor/pump to
ensure sufficient air flow and cooling.
Cut deck/counter to fit using the undermount template
7
provided as follows:
•
Position the template so that the desired undermount
guidelines are aligned with the rim edge as shown.
•
Using a grease pencil, mark the center lines (denoted
by
on template). Remove template.
•
Measure the distance from the wall, or other fixed point,
to the center lines.
Affix counter to bathtub. Clean any dirt or debris from the top of the bathtub rim. Apply a bead of silicone sealant
8
around the entire rim of bathtub.
Do not use an adhesive or adhesive sealant to secure the counter to the bathtub. If maintenance or remodeling
is required, the counter may have to be removed. Adhesive will permanently bond the counter to the bathtub.
Carefully position the deck/counter over the bathtub. Follow manufacturer's instructions to determine cure time.
Apply a continuous bead of silicone sealant around the entire seam between the counter and the bathtub rim.
9
Allow sealant to cure according to manufacturer's instructions.
Turn on the power supply to the dedicated GFCI protected circuits and check system operation.
10
Installation and Operation
Figure 12 - Template Placement
A
Counter
Figure 13 - Distance Measurement
www.jacuzzi.com
Finishing
Materials
Concrete Board
Caulking Bead
Stud
Skirt Panel
Mounting
Screw
Figure 11
Template
Bathtub Rim
B
D
Template
C
Page 13
Publicité
Table des Matières
Dépannage
