Simons Voss Technologies RouterNode 2 Guide Abrégé page 45

RouterNode 2, GatewayNode 2,
SmartBridge
Reset net-
work config-
uration
IPaddress
EN
5. Release the reset button after one second.
Device flashes green again (see
9
[ 43]
).
}
System configuration is reset.
9
1. Disconnect the power supply (round plug or net-
work cable for PoE).
2. Wait 20 seconds.
3. Press and hold the reset button.
4. Reconnect the power supply (round plug or net-
work cable for PoE).
5. Release the reset button after five seconds.
9 Device flashes green again (see
[ 43] ).
}
Network configuration is reset.
9
NOTE
Unauthorised access with standard access data
The standard access data can be viewed freely. Unau-
thorised persons cannot change the access authorisa-
tions, but they can change the network configuration.
You will then no longer be able to reach the device via
the network and will have to reset it.
Some browsers do not transmit spaces at the begin-
ning of the password.
1. Change the default password.
2. Do not start or end the password with spaces.
You receive the device with the following factory
configuration:
192,168,100,100
9. Reset
Signalling
Signalling
45 / 176