Simons Voss Technologies RouterNode 2 Guide Abrégé page 41

RouterNode 2, GatewayNode 2,
SmartBridge
6 Initial operation
System 3060:
RouterNode 2
MobileKey:
SmartBridge
SmartIntego:
Gate-
wayNode 2
6.1 Signal strength
EN
After installation, the device must be put into
operation. Initial operation varies depending on the
system.
LSM must be able to communicate with RouterNode
2. The connection between LSM and RouterNode 2 is
established by using the WaveNet Manager. For
details, please refer to the manuals for RouterNode 2,
WaveNet and WaveNet Manager.
You can manage network-compatible locks wirelessly
in MobileKey with the SmartBridge. To do this, set up
at least one SmartBridge via the MobileKey interface.
Please refer to the MobileKey and SmartBridge
manuals for details.
You can manage network-compatible locks in
SmartIntego wirelessly with GatewayNode 2. Please
refer to the SmartIntego technical manual for details.
Signal strength, as with all radio devices, depends on
several factors, including:
Centres distance

Structural conditions (e.g. metal surfaces or

reinforced concrete as building material)
Other transmitters in the 868 MHz range (e.g.

wireless microphones or garage door openers)
If you are not satisfied with the operational safety, you
can change the installation location or use an external
antenna (see manual).
6. Initial operation
41 / 176