Maintenance And Inspection - Metabo HPT C 12FDHB Instructions De Sécurité Et Mode D'emploi

English
TRANSPORTATION OF THE MAIN BODY
The vice assembly could be dropped during
transportation. Either remove the assembly
or slip a piece of wood between the vice to
fi rmly secure it.
Drop the head and insert the locking pin
(see P. 13 "Releasing the locking pin").
Lift up the miter lock handle, turn the
turntable as far right as it will go, and secure
the turntable by press down the miter lock
handle to the fi xed position. This will make
the main body even more compact.
When transporting the main body, carry it in
your arms, holding the grip located on the base with both hands.
When transporting with two people, each person should use both their hands to hold the carry
handle, switch handle and the base grip.

MAINTENANCE AND INSPECTION

WARNING:
1. Inspecting the saw blade
Always replace the saw blade immediately upon the fi rst sign of deterioration or damage.
A damaged saw blade can cause personal injury and a worn saw blade can cause ineff ective
operation and possible overload to the motor.
CAUTION:
34
To avoid an accident or personal injury, always confi rm that
the trigger switch is turned OFF and the power plug has been
disconnected from the receptacle before performing any
maintenance or inspection of this tool.
Never use a dull saw blade. When a saw blade is dull, its resistance
to the hand pressure applied by the tool handle tends to increase,
making it unsafe to operate the power tool.
Carry handle
Vice assembly
Base grip
Fig. 38
Head
Switch handle
Turn the
turntable
Miter lock handle
Piece of wood to
secure the vice