Maintenance And Inspection - Metabo HPT C 10FCH2 Instructions De Sécurité Et Mode D'emploi

(4) Remove the bolt, washer (D) and washer (E)
Spindle cover
Fig. 34-a
Spindle lock
Fig. 34-b
(5) Lift the lower guard and mount the saw blade.
WARNING:
When mounting the saw blade, confi rm that the rotation indicator
mark on the saw blade and the rotation direction of the gear case
(see Fig. 1) are properly matched.
(6) Thoroughly clean washer (D), washer (E) and the bolt, and install them
onto the saw blade spindle.
10mm Box wrench
Fig. 34-c
Saw blade
Washer
Bolt
Washer (E)
(Chamfering side)
Fig. 34-d
(7) Press in the spindle lock and tighten the bolt by turning it to the left by
standard accessorie's wrench (10mm box wrench) as indicated in Fig.
34-c.
CAUTION:
∗ Confi rm that the spindle lock has returned to the retract position
after installing or removing the saw blade.
∗ Tighten the bolt so it does not come loose during operation.
Confi rm the bolt has been properly tightened before the power
tool is started.
4 mm Machine screw
6 mm Bolt
Washer (E)
Washer (D)
2. Dismounting the saw blade
Dismount the saw blade by reversing the mounting procedures described
in paragraph 1 above.
The saw blade can easily be removed after lifting the safety cover.
CAUTION:
Never attempt to install saw blades larger than 10 in. (255mm) in
diameter.
Always install saw blades that are 9-21/32" (245mm) to 10 in.
(255mm) in diameter.
TRANSPORTATION OF THE MAIN BODY
The vice assembly could be dropped during transportation. Either remove
the assembly or slip a piece of wood between the vice to fi rmly secure it.
Drop the head and insert the locking pin (see P. 8 "Releasing the locking pin").
Carry Handle
Base Grip
Piece of wood to
secure the vice
Fig. 35
Turn and loosen the side handle, turn the turntable as far right as it will go, and
secure the turntable by turning the handle to the fi xed position. This will make
the main body even more compact.
When transporting the main body, carry it in your arms, holding the grip
located on the base with both hands or carry handle.

MAINTENANCE AND INSPECTION

WARNING:
To avoid an accident or personal injury, always confirm that
the trigger switch is turned OFF and the power plug has been
disconnected from the receptacle before performing any
maintenance or inspection of this tool.
1. Inspecting the saw blade
Always replace the saw blade immediately upon the first sign of
deterioration or damage.
A damaged saw blade can cause personal injury and a worn saw blade
can cause ineff ective operation and possible overload to the motor.
CAUTION:
Never use a dull saw blade. When a saw blade is dull, its resistance
to the hand pressure applied by the tool handle tends to increase,
making it unsafe to operate the power tool.
2. Inspecting the lever
If the M6 hexagonal head bolts (2) are loose, align the sides of the fence
and saw blade with the steel square. After adjusting the saw blade and
fence to a ninety-degree angle, tighten the lever securing hexagonal head
bolts (2).
Lever
Hex. head bolt
Fig. 36-a
English
Head
Side Handle
Vice Assembly
15