Maintenance And Inspection - Metabo HPT C 3610DRA Instructions De Sécurité Et Mode D'emploi

English
ABOUT ERROR LAMP OF AC/DC ADAPTER
Status
Before use
Power on
Adapter
Power
suspended
Power
Box
suspended

MAINTENANCE AND INSPECTION

WARNING
To avoid an accident or personal injury, always
confi rm that the trigger switch is turned OFF
and pull out the battery or AC/DC adapter before
performing any maintenance or inspection of
this tool.
1. Inspecting the saw blade
Always replace the saw blade immediately upon the
fi rst sign of deterioration or damage.
A damaged saw blade can cause personal injury and
a worn saw blade can cause ineff ective operation and
possible overload to the motor.
CAUTION
Never use a dull saw blade. When a saw blade is
dull, its resistance to the hand pressure applied
by the tool handle tends to increase, making it
unsafe to operate the power tool.
38
Indications of the indicator lamp
Power
Lamp
(GREEN)
Blinks
Lights
Blinks
Lights for 0.5 seconds. Does not light
for 0.5 seconds. (off for 0.5 seconds)
Blinks
Lights
Lights for 0.1 seconds. Does not light
for 0.1 seconds. (off for 0.1 seconds)
Blinks
Lights for 0.5 seconds. Does not light
for 0.5 seconds. (off for 0.5 seconds)
Table 6
Error lamp
(RED)
Light off
Light off
2. About Handling the Motor (see Fig. 2)
Winding of the motor is said to be the heart of this tool.
Exercise utmost caution not to damage the winding by
exposing it to wash oil or water.
NOTE
Accumulation of dust and the like inside the motor can
result in a malfunction.
After using the motor for 50 hours or so, carry out
no-load running, and blow in the dry air from a wind
hole at the motor's rear. Such action is eff ective to
discharge dust and the like.
3. Inspecting the screws
Regularly inspect each component of the power tool
for looseness.
Re-tighten screws on any loose part.
WARNING
To prevent personal injury, never operate the
power tool if any components are loose.
Indicates
Plugged into power
source
Tool can be used
Adapter cannot be used
due to high temperature.
(Can be used once the
adapter is cooled)
Overload
Cannot be used because
the temperature in the box
is too high
(Can be used once the
box is cooled)