Metabo HPT C 12FDHB Instructions De Sécurité Et Mode D'emploi page 21

10. Miter detent override button (Fig. 14)
The miter detent override button allows for the table to be micro adjusted, disengaging the
positive detent stops feature. When a required miter angle is close to a positive detent stop,
this override prevents the wedge on the miter arm from slipping into that detent slot on the
base.
(1) Unlock the turntable by lifting up the miter lock handle.
(2) Press down on the positive stop locking button and press the miter detent override
button in, then release the positive stop locking button while pressing the miter detent
override button in. The detent override is now engaged.
(3) Turn the turntable to the desired angle, secure the turntable at the desired angle by
pressing the miter lock handle.
(4) To disengage the miter detent override button, press down again on the positive stop
lock button.
11. LED lighting system (Fig. 15) [XACT CUT LED™]
CAUTION:
LED light switch
Shadow of blade teeth
projected onto workpiece
Fig. 15
Do not stare at operating lamp. Staring into the light beam may
result in serious injury or vision loss.
The LED lighting system [XACT CUT LED™] casts
the shadow of the blade onto the workpiece. This
results in greater accuracy of cuts and requires no
adjustments.
To use this feature, turn the LED light switch on.
Bring the motor head down so the blade is
approximately 1/4 in. (6 mm) from the workpiece.
The shadow of the blade will be projected onto the
workpiece, indicating where the blade teeth will make
contact as the cut is made.
English
21