Before Using - Metabo HPT C 12FDHB Instructions De Sécurité Et Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English

BEFORE USING

1.
Make sure the power source is appropriate for the tool.
WARNING:
2.
Make sure the trigger switch is turned OFF.
WARNING:
3.
Check the saw blade for visible defects.
Confi rm that the saw blade is free of cracks or other visible damage.
4.
Confi rm that the saw blade is attached securely to the power tool.
Using the supplied 6 mm hex. bar wrench, tighten the 8 mm bolt on the saw blade spindle to
secure the saw blade.
For details, see Fig. 37-a, Fig. 37-b, Fig. 37-c and Fig. 37-d in the section on "SAW BLADE
MOUNTING AND DISMOUNTING".
5.
Check the lower guard for proper operation.
Fig. 7
WARNING:
6.
Confi rm the position of the spindle lock before using the tool.
After installing the saw blade, confi rm that the spindle lock has been returned to the released
position before using the power tool (see Fig. 2).
7.
Check the Power Receptacle.
To prevent overheating, accidental stopping or intermittent operation, confi rm that the
power cord plug fi ts properly in the electrical receptacle and does not fall out after it is
inserted. Repair or replace the receptacle if it is faulty.
14
Never connect the power tool unless the available AC power
source is of the same voltage as that specifi ed on the nameplate
of the tool.
Never connect this power tool to a DC power source.
If the power cord is connected to the power source with the
trigger switch turned ON the power tool will start suddenly and
can cause a serious accident.
Lower guard is designed to protect the operator from coming
into contact with the saw blade during operation of the tool.
Always check that the lower guard moves smoothly and
Lower guard
covers the saw blade properly.
NEVER OPERATE THE POWER TOOL if the lower guard does not
function smoothly.

Publicité

Table des Matières
loading

Table des Matières