Metabo HPT C 12FDHB Instructions De Sécurité Et Mode D'emploi page 20

English
(3) Bevel angle of 48° (right and left) (Fig. 13-c)
Rotate both angle block (A) and angle block (B) from A to direction B. After pulling out
the sub fence, loosen the bevel lock handle and tilt the motor head to place either the
6 mm hex socket screw (A) (when tilted to the left) or the 6 mm hex socket screw (B)
(when tilted to the right) on the base surface. When the bevel angle is set, tighten the
bevel lock handle to secure the motor head.
Angle block (B)
Fig. 13-a
Bevel lock
handle
8. 90° Indicator (For bevel scale) adjustment (Fig. 13-c)
(1) When the blade is exactly 90° (0°) to the table, loosen the bevel pointer screw using a
#2 Phillips screwdriver.
(2) Adjust Indicator to the "0" mark on the bevel scale and retighten the screw.
9. Quick-cam locking lever operation
Miter scale
Unlock
Miter lock
handle
Lock
Miter detent
Postive stop lock
override button
button
20
Bevel pointer
screw
6mm Hex.
Socket Screw (A)
Angle block (A)
A B
A A A
B B B
6 mm Hex.
Socket Screw (A)
Indicator
Turntable
Fig. 14
Angle block (A)
A
B
Fig. 13-c
If miter angles required are NOT one of the nine
positive stops, the turntable can be locked at any
angle between these positive stops by using the
postive stop lock button and miter lock handle.
Unlock the turntable by lifting up the miter lock
handle, grasp the miter lock handle and pressing
down on the postive stop lock button to move the
table to the desired angle, then release the postive
stop lock button. Press down on the miter lock
handle to lock the table in position.
Bevel pointer
screw
6 mm Hex.
Socket Screw (A)
Angle block (B)
A A A
B B B
A
B
Fig. 13-b
Bevel pointer
screw
Indicator
Angle block (B)
Angle block (A)