Metabo HPT C 12FDHB Instructions De Sécurité Et Mode D'emploi page 28

English
CAUTION:
Miter angle
Turntable
scale
Fig. 25
Fence
Ⓐ
(1) Setting to cut crown moldings at positions
right):
Turn the turntable to the right and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
Tilt the head to the right and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
Position the crown molding so that the upper surface (Ⓑ in Fig. 23) contacts the fence
as indicated Fig. 31.
(2) Setting to cut crown moldings at positions
right):
Turn the turntable to the left and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
Tilt the head to the right and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
28
In the case of left bevel angle cutting, slide the sub fence (L) before
operation. (Fig. 25 and 26)
Head
Bevel angle scale
Sub fence (R)
Base
Ⓑ
Table on base
Fig. 27
Sub fence (L)
Fence
Ⓑ
and in Fig. 24 (see Fig. 29; tilt the head to the
35.3°
31.6°
30°
33.9°
and in Fig. 24 (see Fig. 30; tilt the head to the
35.3°
31.6°
30°
33.9°
Head
Bevel angle scale
Base Turntable
Fig. 26
Ⓐ
Table on base
Fig. 28
Miter angle
scale