Transportation And Storage - Singing rock FLASH Mode D'emploi

D. slot for a protective shield
E. sizing mechanism
F. buckle
G. chin strap
H. straps of the headband
I. removable padding
J. frames of the height adjustment system
INSTRUCTIONS FOR USE
This product can be used by a qualified and properly instructed person only. Do not use
the product without reading and understanding the Instructions. The helmet can only
be used for work and rescue. You are personally responsible for the consequences of
an improper use of this product.
Type INDUSTRY and ACCESS can be used between -30 °C to +50°C (-22 °F – 122 °F),
type AERO -10 °C to +50 °C (14 °F – 122 °F). The helmet which had been exposed to
a severe hit must not be used any longer! Remember, no helmet can protect the user
against all possible dangers!
SAFETY CHECK
Check the condition of the whole helmet before each use! In case the condition of the
helmet is not good or you are not sure about the helmet's good condition, do not use it.
HELMET ADJUSTMENT
(Fig. 2) Adjust the height of the helmet by positioning the plastic frames.
a) the position for a larger head
b) the position for a smaller head
Make sure that the left and right side of the helmet are adjusted symmetrically. You can
adjust the height in three ways:
• all frames are in the a) position – the L size
• the rear frames are in the a) position, the front frames are in the
b) position – the M size
• all frames are in the b) position – the S size
(Fig. 3) Adjust the length of the side straps according to the size of your head. If you use
the helmet with an earmuff, loosen the strap so that it does not clash with the earmuff.
(Fig. 4) Loosen the helmet with the rotary wheel before putting it on your head. After
putting the helmet on, tighten the mechanism so that the helmet sits firmly on your
head.
(Fig. 5) Adjust the length of the chin strap so that it keeps the helmet safely on your
head.
(Fig. 6) Use the helmet only in the ideal position. That is the only way it can provide you
with the maximum safety.
If you cannot adjust the helmet so that it sits firmly and safely on your head, do not
use it.
ACCESSORIES
(Fig. 7) To increase visibility, place the attached reflective stickers on the helmet
according to the picture. You can place the stickers on the glossy surfaces of the helmet
only. You can only use your own stickers or labels if these do not damage the ABS/
PC material.
(Fig. 8) Adjust the length of the headlamp strap properly. Pull the strap between the
shell and the clips enough for the headlamp to stay firmly and safely attached to the
helmet.
(Fig. 9) The accessories compatible with the universal slot can be attached to the sides
of the helmet. To remove the accessories unblock the safety lock.

TRANSPORTATION AND STORAGE

(Fig. 10) WARNING! This helmet can be damaged by the solvent-based chemicals and
the chemicals containing solvents (adhesives, paints). Do not expose the helmet to
direct heat sources or long-term sunshine. Transport the helmet in the attached cover or
another textile cover of a similar kind.
MAINTENANCE
(Fig. 10) For cleaning use only clean water with temperature up to 30 °C (86 °F), a
pH-neutral soap and a soft textile. Dry the helmet away from direct heat sources.
MARKING LEGEND (Fig. 11)
A. manufacturer
B. the weight of the helmet
C. the helmet is designed for people with head circumference of 53–63 cm
D. meets the requirements for use in -30 °C (-22 °F)
E. meets the requirements for protection against the random voltage exposure up to 440 V
3