Safety
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
Gas and Electrical
Requirements and
Grounding Instructions
Page 2
require a conversion kit. Make certain your range and gas type are the same. Refer
to the product rating label which can be located as indicated on Page 45.
Important: All ranges must be installed with a backguard. The 30" model comes with a low
back. For all other models, one of three available backguards must be ordered
separately and installed at the back of the range. The three backguard choices
include a Low Back, Pot and Pan Shelf, or Island Trim. Before using the range,
insure that it is equipped with a proper backguard. DO NOT attempt to use a
backguard that is not designed to fit your particular model range. Refer to the
Installation Instructions accompanying this appliance for more information.
This manual contains important Care and Use information for all Thermador Profes-
sional® Ranges. When using this manual, it is critical that you know the model num-
ber of your range, as some information will be unique to each range. The model
number may be found on the rating plate located on the range as identified on
Page 45 of this manual. The charts on the following pages summarize the various
range models and identify the features of each range.
PLEASE READ CAREFULLY
30" Dual-Fuel Models:
240/208 volts, 60 Hz., 35 Amp electrical circuit required for each line.
36" Dual-Fuel Models:
240/208 volts, 60 Hz., 35 Amp electrical circuit required for each line.
48" Dual-Fuel Models:
240/208 volts, 60 Hz., 50 Amp electrical circuit required for each line.
CAUTION
When connecting the unit to propane gas, make certain the pro-
pane gas tank is equipped with its own high-pressure regulator in
addition to the pressure regulator supplied with the range. The
maximum gas pressure to this appliance must not exceed 14.0
inches water column (34.9 mb) from the propane gas tank to
the pressure regulator.
WARNING
To avoid possible burn or fire hazard, a backguard designed specif-
ically for this range must be installed whenever the range is used.