Safety Instructions - Kulzer heraceram Mode D'emploi

General firing table
NP
Primer
Starting [°C] 600
temperature
Pre-drying [min] 3
and
pre-heating
time
Temperature [°C/min] 100
increase
Final [°C] 950
temperature
Hold time [min] 1
Vacuum [°C] 600
start
Vacuum [°C] 950
stop
Only when veneering non-precious metal ceramic bonding alloys
1
Or at the manufacturer's recommended oxide firing temperature
2

Safety instructions:

Hypersensitivity to the product or its components cannot be ruled out in individual cases – in a sus-
pected case, please contact the manufacturer with regard to the ingredients. Only to be used by dental
specialists for its intended purpose. The data indicated corresponds to the best of our knowledge and
is based on internal investigations. Do not swallow or consume this product. Avoid contact with the
eyes. If the product does come into contact with the eyes, rinse them thoroughly with plenty of water
immediately and consult an ophthalmologist. In the case of a known or suspected allergy to the ceramic
ingredients, the use of this product is contraindicated. In the case of a suspected allergy, an allergy test
is recommended before treatment.
Please note the information on the corresponding safety data sheet!
If you wish to contact us with regard to the product, please always indicate the lot designation.
Designation lot : See note on packaging.
Pre- Paste Powder
Opaque opaquer opaquer
1 1
600 600 600
6 6 2
100 100 100
980 880 880
2
10 1 1
600 600 600
980 880 880
2
Shoulder Shoulder 1 st
ceramics ceramics Dentine
HM 1 HM 2
600 600 600
4 3 5
100 100 100
870 860 860
1 1 1
600 600 600
870 860 860
2 nd Glaze Mono
Dentine dentine
and glaze
firing
600 600 400
5 4 5
100 100 100
850 850 850
1 0.5–1 0.5–1
600 – 400
850 – 850
Dated: 2017-07
Correction Shoulder
material ceramics
LM
600 600
4 4
100 100
810 790
1 1
600 600
810 790
5