Connections - Yamaha RX-V495 Mode D'emploi

Never plug in this unit and other components until all connections have been completed.
CONNECTIONS WITH OTHER COMPONENTS
When making connections between this unit and other components, be sure all connections are made correctly, that is to say L
(left) to L, R (right) to R, "+" to "+" and "–" to "–". Also, refer to the owner's manual for each component to be connected to this unit.
* If you have YAMAHA components numbered as !, #, $, etc. on the rear panel, connections can be made easily by making sure
to connect the output (or input) terminals of each component to the same-numbered terminals of this unit.
Turntable Monitor TV
CD player
GND terminal (for turntable use)
Connecting the ground (earth) wire of the turntable to the GND terminal will normally minimize hum, but in some cases, better
results may be obtained with the ground wire disconnected.
16

CONNECTIONS

DVD player,
LD player, etc.
Tape deck, TV/DBS tuner
MD recorder, etc.
SWITCHED AC OUTLET(S)
U.S.A., Canada, Singapore, China and General models
........................................................... 2 SWITCHED OUTLETS
Australia model ..................................... 1 SWITCHED OUTLET
Use these to connect the power cords from your components to
this unit.
The power to the SWITCHED AC OUTLET(S) is controlled by
this unit's STANDBY/ON or the provided remote control
transmitter's POWER. These outlets will supply power to any
component whenever this unit is turned on.
The maximum power (total power consumption of components)
that can be connected to the SWITCHED AC OUTLET(S) is
100 watts.
VCR
(Video cassette recorder)
(U.S.A. model)
To AC outlet